Flyers
Mon-Fri 7am-1am EST Sat-Sun 8am-11pm EST
1(888)985-6937
Mon-Fri 7am-1am EST Sat-Sun 8am-11pm EST
My Store: | Change | Find A Store  
X
Store #
Phone:
Fax:
Hours:
Monday - Friday
Saturday
Sunday
masterPageBottomBannerImg
Home > Ideas & Tips > Set up a Tent

Set up a Tent

Close Video Content

Kids' Drop Cloth Play Tent


Kids will love this easy-to-make tent for backyard camping and weekend fun. Fold it flat and store it when they're done.

Drill
Countersinking pilot bit for #8 screws
3/8" drill bit
12 - 1"x2"x6' boards
#8x1-1/4" wood screws
2 - 3/8" wing nuts
2 - 3/8" flat washers
2 - 3/8"x2" hex bolts
6'x 9' canvas drop cloth
Drop Cloth Tent Project

1. Wash and dry the drop cloth to soften it. (Avoid hot settings on the washer or dryer that may cause excessive shrinkage.) Sand the faces, edges, and ends of each 1"x2"x6' board to remove any sharp edges or rough spots.


2. Find the four straightest boards to use as the vertical ends (A) for both frames. Measure 20-1/2" down from the top end of each board and mark the center of the 1-1/2"-wide faces where shown. Drill 3/8" holes at each mark, taking care to keep the holes 90 degrees to the wood surface.


3. On a flat surface, place two of the vertical ends (A) on edge so they're parallel and about 6' apart. Check that the 3/8" holes are at the top end. Lay cross brace (B) with the face spanning the two parallel boards and flush with their ends. Use a carpenter's square to check that they're 90 degrees to each other. Drill two countersunk pilot holes about 3/8" from the edges of the top board. Then add glue and screw the top board to the two vertical boards.


4. Measure 23" from the edge of the bottom board and mark the two vertical boards. Glue, drill, and screw a second horizontal board in place. Measure another 23" and repeat to add a third horizontal board to complete one tent frame side. Repeat the previous step and this one to make a second side; let the glue dry.


5. To join the frames, stand them together with the holes overlapping. Place a washer on a 3/8"x2" hex bolt, slide the bolt through the holes, and hold it in place with another washer and a wing nut. Repeat for the other hole.


6. Spread the two sides apart to form the "A" shape. Drape the prewashed drop cloth over the frame and confirm that it will reach from one bottom board to the other. Then staple one end to the bottom board on one side, pulling it tight as you go. Pull the cloth tight over the top and staple it to the opposite bottom board. Lightly hammer any staples not completely driven in place.

7. Drill and screw (but don't glue) a reinforcement (C) on top of the stapled bottom board (B) to create a clean look and keep any staples from popping loose. Repeat for the other side.

Your Recently Viewed Items
You have no recently viewed items. After viewing product detail pages or search results, look here to find an easy way to navigate back to products you are interested in.
Your Recommended Items

You currently have no recommended items. Browse a few more items to give us an idea of what you like.
sitelink
© 2012 - 2016 Lowe's ®. All rights reserved. Lowe's and the gable design are registered trademarks of LF, LLC v2.4.0.46 release/EV2.4
1001
Server: WWW85 Created On: 12/8/2016 10:20:47 AM